Model Analysis and adding Contact Sets to stop Parts from going through each otherCheck an Assembly for InterferenceInterference AnalysisSets 1 and 2Process - ResultsModified AssemblyPowerPoint PresentationSlide 8Slide 91SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyModel Analysis and adding Contact Sets to stop Parts from going through each otherChecking for Interference between partsin the Assembly Model.Making Parts stop when coming into contact with others in the Assembly Model.2SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyCheck an Assembly for Interference3SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyInterference Analysis4SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologySets 1 and 2set 1set 25SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyProcess - ResultsTo eliminate interference, modify a part or parts, or change an assembly constraint.6SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyModified AssemblyIncreased tube hole size.Check interference again.7SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyAdding Contact Sets to Parts so Parts will not move through other Parts8SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyAdding Contact Sets to PartsSelect the Part and RC and select contact set.Go to the other part and select the part and RC and select contact set.Go to the Inspect Tab and select Activate Contact Solver.The part will now stop when it makes contact with the other part.9SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyAdding Contact Sets to PartsThe part will now stop when it makes contact with the other part in either
View Full Document