CAD Section ViewsCreating a Section ViewCutting Plane LineSection ViewCreate a Full Section ViewSlide 6Adding the Full Section ViewFull Section ViewHalf Section ViewsHalf SectionsCreate a Half Section ViewCreating a Half Section ViewAdding the Half Section ViewHalf Section ViewOffset Section ConceptOffset Section ViewsCreate an Offset Section ViewSlide 18Offset SectionFinal DrawingSheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyCAD Section ViewsFull SectionsHalf SectionsOffset Sections2SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyCreating a Section ViewCreate the view you wish to section (*.idw file)Select the Section View icon (Create toolbar)Draw a Cutting Plane in an existing view at the proper location for the type of section view needed Select the side to place the view3SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyCutting Plane LineCutting Plane Line for Section View–Select the view to be sectioned–Sketch the cutting line–Cursor position determines cut side4SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologySection ViewIdentify the cutting plane line5SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyCreate a Full Section ViewCreate the Standard Views6SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyCreate a Full Section ViewDraw a Cutting Plane line through the center of the hole in the partSelect the view, draw the line7SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyAdding the Full Section View8SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyFull Section View9SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyHalf Section ViewsAxis10SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyHalf SectionsOptional Arrow11SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyCreate a Half Section ViewStart a new drawing file and add the standard views12SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyCreating a Half Section View Draw a Cutting Plane line as shown in the front view.13SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyAdding the Half Section View•Position the Section View to the right of the existing view.14SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyHalf Section View15SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyOffset Section Concept16SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyOffset Section Views17SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyCreate an Offset Section ViewStart a new drawing file and add the top view18SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyCreate an Offset Section ViewDraw a Cutting Plane line through the center of the holes in the part.When finished RMB -> continue19SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyOffset SectionSelect the section view location20SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyFinal
View Full Document