Model AnalysisFully Constrained ProfileExtruded PartDefining Part DensityCheck Material Properties - 1Check Material Properties - 2Sanity CheckModify Part and Update PropertiesNew Part Properties1SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyModel AnalysisPhysical Properties of Parts2SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyFully Constrained Profile3SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyExtruded Part4SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyDefining Part DensityAutodesk Inventor: Select material name – Apply5SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyCheck Material Properties - 1Density value may be set or changed in this dialog box.6SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyCheck Material Properties - 2Mass moments of inertia (global, principal, radius of gyration) are used in rotational dynamics (they are NOT the same as area moments of inertia, which are used in stress calculations)7SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologySanity CheckDevelop a variety of test cases to assure that you know how software performs tasks.8SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyModify Part and Update Properties9SheetCourse: Introduction to Engineering Graphics and Visualizationcopyright 2011, Georgia Institute of TechnologyNew Part
View Full Document
Unlocking...