Chapter 5Center LinesSlide 3Slide 4Precedence of LinesSlide 6Slide 7Projection of an ObjectSlide 9Slide 10Chapter 5MultiviewSketching & ProjectionPart 4Print handoutsSelect File, PrintEdit the following selections to read:Select the OK button2Center Lines1/16” GAP1/8” DASH¾” – 1-1/2” LONGThin dark linePurpose of a center line?To show location of a hole, arc, cylinder, etc.3Center LinesExtend center line ¼” past the holeHOW MANY CENTER LINES MISTAKES? Extend center line ¼” past the hole4Center Lines¼” past the end of the hole and/or cylinderEnd of cylinderEnd of holeEnd of hole5Precedence of LinesHIDDEN LINES TAKE PRECEDENCE OVER CENTER LINESOBJECT LINES TAKE PRECEDENCE OVER HIDDEN LINES¼” FROM END OF HOLE1/16” GAP6Center Lines1/16” gapIf longer than 1-1/2” add a dash in the middleINCORRECT7Fillets and Rounds: Self locating, so do NOT add center lines, but do draw where sharp corner would be.8Projection of an ObjectPOOR PRACTICEPREFFEREDWhy?Adds clarity9Projection of an ObjectPOOR PRACTICEPREFFERED PRACTICE10Projection of an ObjectPOOR PRACTICEPREFFERED
View Full Document