Name _____________________________ KKIINN 333355 -- BBiioommeecchhaanniiccss LAB: Projectile Motion Introduction: Performance in many sport activities is dependent on the ability to either control or predict the motion of a projectile. In attempting to produce a particular trajectory of a projectile, we have the ability to manipulate three basic characteristics of the projectile at the instant it is released into the air: its speed, the angle at which it is projected, and the height at which it is released above the landing area. Of particular interest in many examples of projectile motion is the horizontal distance traveled by the projectile (i.e., its range). In fact, this represents the performance measure in many sport events (e.g., long jump, shot put). This laboratory focuses on the effect of speed, angle, and height of release on projectile flight. Some of the issues of concern include: a) how does each individual factor affect the horizontal distance of the projectile, b) how sensitive is horizontal distance to each of these factors, and c) what interrelationships exist among these factors. In the absence of air resistance, both the vertical and horizontal components of a projectile's motion represent uniformly accelerated motion (i.e., constant acceleration). In the case of the vertical component, the constant acceleration equals that produced by gravity (–9.8 m/s2). Because gravity affects only the vertical motion, horizontal acceleration equals zero (remember again that this assumes that air resistance effects can be ignored). The equations of uniformly accelerated motion that allow us to predict characteristics of a projectile's flight include: vf = vi + at (1) d = vit + ½at2 (2) vf2 = vi2 + 2ad (3) where vi and vf represent initial and final velocities for a time period t, a equals the constant acceleration, and d represents the displacement. These equations can be applied to either the vertical or horizontal components of a projectile's flight. When applied to the horizontal motion (i.e., a = 0), equations 1 and 3 simply indicate that the horizontal velocity at the end of the projectile's flight equals that produced at the beginning of its flight (i.e., vf = vi). Equation 2, when applied to the horizontal component, reduces to: d = vit This can be written more specifically to reflect a focus on horizontal motion: dh = vhttot (4) where dh is the range or horizontal displacement of the projectile, vh is the horizontal component of velocity at release (and at any other time during the projectile's flight), and ttot is the total time of flight (tup + tdown). Purpose: To examine the association between a projectile's initial flight conditions (i.e., speed, angle, and height of release) and the resulting motion (i.e., vertical and horizontal speed, horizontal distance, and time of flight) with particular relevance to throwing and the shot put.2Exercises Part 1--Throwing for maximal height or distance Each student will complete two throws by bouncing a tennis ball off the floor and into the air. For the first throw, the student should attempt to maximize the vertical height to which the ball travels. For the second throw, the student should try to maximize the horizontal distance the ball travels (i.e., maximize the range). Note: Try to throw the ball down with the same amount of force for each condition. For each throw, the following data should be recorded: 1. The total horizontal distance, dh, traveled by the ball in the air (measured as the straight-line distance between the first two points of contact with the ground). 2. The total time, ttot, the ball spent in the air (i.e., the flight time). Fill out the chart below with the data collected from each throw and calculate the other variables using the equations of uniformly accelerated motion. Throw Horizontal distance dh Total time of flight ttot Vertical velocity (i) vi Horizontal velocity vh Resultant velocity vr Vertical distance dv Angle of release θ Max Height Max Range Show your work here Questions to answered: 1. How did you change your throwing technique (indicated by the manner in which you threw the ball) between the throw for maximum height versus maximal range? 2. Looking at the data presented in table above, what could you have done to improve your performance for each of the conditions?3Part 2--Sensitivity of performance to speed, angle, and height: Use the computer program PROJEC1 to determine the effect of 10% increases in the speed, angle, and height of release on a projectile's flight. Release conditions Flight results speed angle height vv vh ttot dh nominal case 10 m/s 38 deg 2.0 m ______ ______ ______ ______ +10% speed 11 m/s 38 deg 2.0 m ______ ______ ______ ______ +10% angle 10 m/s 41.8 deg 2.0 m ______ ______ ______ ______ +10% height 10 m/s 38 deg 2.2 m ______ ______ ______ ______ Compute the percent change in horizontal distance of the projectile for each of the three 10% manipulations compared with the nominal case: i.e., [(10% condition – nominal case) / nominal case] · 100% +10% speed________ +10% angle________ +10% height________ Show your work here Questions to be answered: 3. a) To which of the three release factors was horizontal distance most sensitive? b) Considering the second equation of uniformly accelerated motion expressed specifically for horizontal distance (dh = vhttot), are these results as you would expect? Explain. 4. Look carefully at the changes that occurred in vertical speed, horizontal speed, and total time of flight with each manipulation. Are these changes as you would expect? Describe and explain.4Part 3--The case of the maturing shot putter: Factors that affect the optimal angle of release in the shot put for various speeds and heights of release should be important concerns when coaching athletes of various heights and muscular strengths and when designing equipment for use by athletes of different age and physical maturity. Use computer program PROJEC2 to determine the optimal angle of projection and the corresponding horizontal displacement (dh) under the following conditions: A. Different strength (reflected by speed) only (using the same shot) speed height opt. dh "strong" 12 m/s 2.1 m ______ ______ "medium" 8