ECEN 215 – PRIN OF ELECTRICAL ENGRFall 2018Lab 7: Operational Amplifier Integrator and Active FilterECEN 215 – PRIN OF ELECTRICAL ENGRFall 2018 Lab 7: Operational Amplifier Integrator and Active Filter Submitted by:Student Name UIN: Section # Group # 512 Date Performed: November 5th , 2018I. ObjectiveThe purpose of this lab was to understand the differences between the 6different kinds of waves in an ACcircuit.II. Procedure1. The circuit was constructed with two 10k resistors in parallel for R2, a 1k resistor for R2, and a10F for C1.2. The wave generator was set to the required settings. 3. Vin and Vout and the phase shift was measured with the scope tool. 4. Steps 2 and 3 were repeated with a square wave and then a triangle wave. III. Difficulties1. There were no difficulties encountered in this lab experiment.IV. ResultsA. The resistor values for R2 were 9.50 k and 9.71 k in parallel and R1 had a value of .984 k.B. Sine Wave results:- Vin: 497 mV- Vout: 178.1 mV- Phase shift: -23.31 msC. Triangle Wave results:- Vin: 497.5 mV- Vout: 120.3 mV- Phase shift: 23.69 msD. Square Wave results:- Vin: 497.8 mV- Vout: 327.1 mV- Phase shift: 24.63 msV. Conclusion In conclusion, it was found that in an AC circuit when the wave is changed, the Vin value as well as the phaseshift stay the same while the Vout value is the only one that