In the RIP lab description you will find a line regarding the router settings as follows Routing Table Export Once at End of Simulation However in riverbed you cannot do this from the router attributes window To do this you have to do the following Select the router select the Protocols menu IP Routing Export Routing Table Obtain the IP addresses of the Interface You cannot open the files using Riverbed directly For this you have to open file explorer and have to go the directory where your files are saved It may be something like op models your initials RIP project On that directory you will find all the files such as your initials RIP NO failure ip addresses gdf You have to open the file with wordpad Then in wordpad go to the page setup and set the page to be portrait Then you can get the results similar to the one mentioned in the pdf Unfortunately you have to draw the layout for now since you cannot open the file using OPNET If we find some easier way to do it we will broadcast Getting the Ping Report From the Project Editor menu select DES Results View Results then in the DES Run 1 Tables tab expand the following hierarchy Object Tables Campus Network router Performance Ping Report for Campus Network router at 100 seconds Click Show to bring up the table of results in a separate window Note Your results may differ from the sample ping results given above Note Your results may differ from the sample results given above
View Full Document
Unlocking...