GY 302 Crystallography and Mineralogy Important Optical Mineralogy Terms and Concepts Part One: Basic Stuff Light is a propagating wave front that moves fast. The velocity of light is a vacuum is one of the most important constants in science: Vc = 2.988 x 108 m/s (this constant is usually designated C) In any other medium beside a vacuum, the speed of light is less than C. When light travels from one medium to another (vacuum to air, air to water), interesting effects occur. The physics behind this is portrayed in the following sketch: The Index of Refraction (n) of a material is a ratio of C to the speed of light through a material (Vx). nx = C/Vx The index of refraction for some common substances is given in the table below: Material nx air 1.000027 water glass 1.50 minerals 1.40-3.22 The index of refraction of a mineral can be relatively easily measured in a laboratory, but it is important to minimize any dispersion of light that might occur. This is the prism effect that occurs when white light is split up into it’s component colors:Light produced from an incandescent source (AKA light bulb) is emitted as waves that have no preferred vibration direction (think of this as the orientation of the waveforms). In order to do petrography (which is complex enough as it is), you need to restrict the light that passes through your mineral specimens to waves that vibrate in a single direction. This is done with the help of a polarizing lens: Do not confused polarized light with monochromatic light. The former is white light that vibrates in a single direction. The latter is colored light of a single frequency (e.g. 550 nm is the pure red light you get in a laser pointer). When it comes to light transmission, most geologists recognize 3 classes of minerals: 1) Transparent (minerals that transmit light and images through them) e.g., selenite 2) Translucent (minerals that only transmit light) e.g. quartz 3) Opaque (minerals that do not transmit light at all) e.g., galena, pyrite. Transmission light microscopy (AKA thin section microscopy or optical microscopy) studies transparent and translucent minerals. The vast majority of minerals fall within these classes. Even minerals that you might at first think are opaque (pyroxene, biotite) are translucent if they are sliced thinly enough. The way that light travels through minerals is entirely dependant on the crystalline structure of the minerals. In order to understand this, you need to recall the seven crystallographic systems that caused you so much hell in the crystallography component of this class.Crystal System Axes Angles between axes 1 Cubic a = b = c " =$ =( =90° 2 Tetragonal a = b ≠ c " =$ =( =90° 3 Hexagonal a= a1=b≠ c " =$ =120° , ( =90° 4 Trigonal a= a1=b≠ c " =$ =120° , ( =90° 5 Orthorhombic a ≠ b ≠ c " =$ =( =90° 6 Monoclinic a ≠ b ≠ c " =$ =90° , ( ≠ 90° 7 Triclinic a ≠ b ≠ c " ≠ $ ≠ ( ≠ 90° For some minerals (e.g., the cubic system), light is transmitted equally (in velocity or wavelength) in all directions through the crystal. The index of refraction is also uniform in all directions. These minerals are said to be isotropic. In the rest of the mineral classes (termed anisotropic), the velocity of light is not consistent. There is a preferred orientation where lighttravels faster than in other directions. In order demonstrate the different ways that light can travel through minerals and to summarize the optical properties of minerals, microscopists came up with the concept of an indicatrix. This is a geometrical figure that is produced around a point using the indices of refraction as radii. Isotropic minerals like the cubic mineral system have spherical indicatri (figure 1 below). Anisotropic minerals come in two major flavors. Minerals in the tetragonal and trigonal/hexagonal classes are termed Uniaxial and the indicatrix is defined as a biaxial ellipsoid (2 different axes; figure 2). Minerals in the remaining classes (orthorhombic, monoclinic, triclinic) are termed Biaxial and the indicatrix is defined as a triaxial ellipsoid (3 different axes; figure 3):All anisotropic minerals do something interesting to light rays that pass through them. They divide the light (including polarized light) into two components which vibrate in mutually perpendicular planes. In the simplest case (that of the uniaxial minerals), one of these rays has a constant velocity regardless of the direction that the light passes through the mineral. This ray is called the ordinary ray or o-ray for short. The other ray is called the extraordinary ray (or e-ray) and it’s velocity varies with direction. This splitting of rays is known as double refraction (or brirefringence1), and although it is difficult to envision, most geology students have experienced it’s effects in at least one mineral: optical calcite (or Icelandic spar). So pronounced is the double refraction in calcite that it is possible to see a double image when a good crystal is place on top of a piece of paper (think back to GY 111). In the same way that we can use the indicatrix to portray the various indices of refraction for the mineral classes, it is possible to construct a graphic image summarizing the velocity and vibration direction differences of the o- and e-rays and in so doing, explain while double refraction occurs in anisotropic minerals. The figures below shows the two possible situations that might occur in uniaxial minerals: (1) the o-ray is slower than the e-ray (uniaxial negative), (2) the o-ray is faster than the e-ray (uniaxial positive). Both figures are from Robinson and Bradbury (1992) 1 I don’t like to equate double refraction to birefringence. I prefer the more anal interpretation of birefringence which is a measured difference between the indices of refraction of the o- and e- raysThere is only one orientation where the velocity of the o-ray and the e-ray is the same (the places where the circle and the ellipse meet in the figure on the previous page). This orientation is called the optic axis and this is the only direction where double refraction does not occur. The orientation of the optic axis frequently follows crystallographic axes (e.g., in quartz, the optic axis is parallel to the c axis), but not always. In calcite, the optic axis is tilted relative to the crystal faces which is one of the reasons why the double refraction is so