Photoshop Techniques • Photo Edges • Page 1©2001. Randy S. Schaeffer. All Rights Reserved.TechniquesPhotoshopHow to…CREATEPHOTO EDGESUsing the technique described below, you will be ableto produce special edges on your scanned photographs(such as the examples shown on page 3). The secret toquick and easy success is using Photoshop’s QuickMask feature in conjunction with certain Filters.STEP 1: Quick Mask SettingsPhotoshop’s Quick Mask mode button is found at thebottom of the Toolbox (below).When you double click on the Quick Mask mode iconthe following dialog box appears.Quick Mask ModeNormal Mode55Enter the settings shown above (choose Selected Areasunder Color Indicates and set the Opacity to 100%),and then click on OK.Photoshop Techniques • Photo Edges • Page 2©2001. Randy S. Schaeffer. All Rights Reserved.STEP 2: Making a SelectionA: After opening your photo, use either theRectangular or Elliptical Marquee tool to select theportion of the photo that you want to put a specialedge around. (NOTE: Make sure you are in theNormal mode before doing this.)B: Since you may want to experiment with differentfilters, you might want to save your selection bypulling down the Select menu to Save Selection.C: Click on the Quick Mask mode icon. Photoshopautomatically replaces the selected area with acolored overlay (the color is the one you chose inthe Quick Mask Options dialog box).STEP 3: Applying FiltersWhile you are in the Quick Mask mode, any filters youapply will only affect the masked overlay. Thephotograph itself will not be affected until later.Pull down the Filter menu to the Stylize submenu andselect Diffuse (set on Normal). Apply the Diffuse filterseveral more times (we applied it 10 times here).• HINT: To reapply the same filter, simply pressCommand-F on the keyboard.Step 2BStep 2DStep 3Photoshop Techniques • Photo Edges • Page 3©2001. Randy S. Schaeffer. All Rights Reserved.STEP 4: Viewing Your New SelectionA: Click on the Normal mode icon and the selectionborder will have changed to reflect the changes youmade with the filters. The edge should now have asomewhat jagged, uneven appearance.B: Pull down the Select menu to Inverse to select thebackground.C: Press the Delete key to remove the background.D: Pull down the Select menu to Deselect, and you arefinished.E: At this point, depending on how much of theoriginal photograph you selected, you may want tocrop the photo using the Cropping tool.Step 4AStep 4CGaussian Blur (on Blursubmenu, set at aradius of 10) followedby Ripple (on Distortsubmenu, set at anamount of 300 andsmall size)Gaussian Blur (on Blursubmenu, set at aradius of 10) followedby Crystallize (onPixelate submenu, setat a cell size of 6)STEP 5: Experimenting with Other FiltersA: Click on the original photograph. Make certainthat you are in the Normal mode.B: Select none to remove the marquee (Command-Dor Deselect on the Select menu).C: Pull down the Select menu to Load Selection to re-establish the original selection. This only works ifyou saved the selection in Step 2C.D: Click on the Quick Mask mode icon.E: Repeat Steps 3 and 4 with different