Exp #3 Addition and Resolution of VectorsANALYSIS OF DATAAnalytical MethodGraphs (Polygon Method) & Sample CalculationsError AnalysisDiscussionPHYS 163 Lab Section A <Your Name>Prof. Augensen <Date Performed>Exp #3 Addition and Resolution of VectorsNames of Lab PartnersDATA**Insert MS Excel Data Sheet(s) here** Note: Delete the items which appear in blue throughout this document before submitting your report. They are merely intended to guide you through the report. 2PROCEDUREAs stated in the lab manual. ANALYSIS OF DATA Analytical Method**Show sample calculation for Analytical Method: **a) Ax = A cos , Ay = A sin (or similarly use Bx, By, or Cx, Cy)b) Rx = Ax + Bx + Cx, Ry = Ay + By + Cyc) R = (Rx2 + Ry2)1/2 d) = arctan(Ry / Rx) + 180Graphs (Polygon Method) & Sample Calculations1. Graph showing vectors done carefully and correctly?2. Calculation of mass of R R and angle from Graphical Method (Note conversion factor 20 g = 1 cm) 3. Calculation of % Differences between Analytical and: a) Graphical b) Direct Table of Results (Analysis Sheet on Excel File) All major results are summarized here3CONCLUSIONError Analysis1. Discuss the range of mass and angle variation on: a) force table and b) graphical method. These ranges should have been used to deduce the uncertainty in the force table (accidental uncertainty) and graphical (instrumental uncertainty) methods. 2. Suggest changes in the experimental design and/or procedure which would make the individualreadings & hence final results more accurate.Discussion1. Were the objectives of the lab met? 2. Discuss whether experimental data (force table) were verified by analytical & graphical methods. In other words, did they agree within their respective uncertainties?3. Which of three methods was most accurate?
View Full Document