Lab 101 My First Digital Design Objective Introductory project walking through new project creation with PSoC Creator Project uses PSoC Creator and the PSoC3 First Touch Kit CY8CKIT 003 to blink a LED by writing to an I O pin Activities and Procedures 1 Start PSoC Creator 2 Create a new project a Select a project name Lab 101 My First Digital Design b Use the default workspace c Use the default device 3 Place a Digital Output Pin in your design a Double click on the icon to configure the digital pin as follows Page 1 of 5 b Close the configuration dialog Page 2 of 5 4 Open the Design Wide Resource Manager two methods a The Design Wide Resource Manager has several editors Each editor has a Tab at the bottom of the manager Select the Pins Tab Page 3 of 5 b Assign Pin 1 pin to P2 0 Drag from the row to the pin location or use the pull down from the Pin column 5 Replace all the code in main c with the code inserted from the main txt file located in the 101 Introduction to the Architecture and Design Flow Lab directory 6 Build the project 7 Start the debugger Page 4 of 5 8 Execute the code by Pressing Continue Page 5 of 5
View Full Document
Unlocking...