DOC PREVIEW
TAMU PHYS 1402 - lab 6.2

This preview shows page 1 out of 4 pages.

Save
View full document
View full document
Premium Document
Do you want full access? Go Premium and unlock all 4 pages.
Access to all documents
Download any document
Ad free experience
Premium Document
Do you want full access? Go Premium and unlock all 4 pages.
Access to all documents
Download any document
Ad free experience

Unformatted text preview:

Experiment 2: Snell’s LawIn this experiment, you will verify Snell’s Law using a refraction cell and laser. You will also observe total internal reflection.MaterialsRefraction Cell2 ProtractorsLaser Pointer*Masking Tape (optional) *Sheet of Paper*Water*You Must ProvideProcedurePart 1: Refraction1. Fill the refraction cell with water ¾ full of water. If there are any bubbles inside the cell, rub or flick them with your finger to get them off the bottom. 2. In the middle of the sheet of paper, create a 360º protractor by overlapping the 0 and 180º marker lines for both protractors. Use masking tape to secure your 360º protractor. 3. Center the refraction cell’s flat side along the 0º base line. The middle of the cell should be located at the origin of your 360º protractor. 4. Shine the laser pointer through the refraction cell at an incidence angle of 0º. You should point the laser through the curved side of the cell and directly at the middle ofthe flat side of the cell. 5. Record the refraction angle of the light coming out of the cell. Remember the incidentand refracted angles are measured from the normal line which are the 90 degrees angles on the protractor.Hints: 1) In order to see a good refracted ray, you may need to move the laser up and down. 2) Make sure the water is still when taking measurements. 6. Repeat Step 4 - 5 for all of the angles listed in Table 3. © 2014 eScience Labs, LLC.All Rights ReservedPart 2: Total Internal Reflection1. Use the same setup as Part 1, adjusting the angle of the laser pointer until you observe total internal reflection. Record the critical angle in Post-Lab Question 1.Table 3: Laser and Refraction Cell DataIncident Angle, θi(Degrees)Reflected Angle, θT(Degrees)Sinθi (Degrees) SinθT (Degrees)0 180 0 05 167 0.087 0.001510 165 0.1736 0.00315 159 0.2588 0.004520 156 0.3420 0.0059725 154 0.4226 0.007430 150 0.50 0.008735 147 0.5736 0.0140 143 0.6428 0.011245 141 0.707 0.0123Post-Lab Questions1. What is the critical angle for a laser beam travel from air to water?2. There are two boundaries where the laser beam changes medium. Describe the two boundaries and determine which one causes the light to refract?© 2014 eScience Labs, LLC.All Rights Reserved3. The two mediums in this experiment are water and air. Which medium is the medium for the incident ray? Which medium is the medium for the refracted ray?4. The index of refraction for water is n=1.33. Use this value to calculate the theoretical critical angle for the laser travelling from water to air. Compare this value to the one you experimentally determined with a percent error calculation.5. Complete Table 3 by computing the sine of the incident and refracted angle.6. Plot a graph of sin(θi) versus sin(θr). 7. Draw in a line of best fit.Hint: You want the y-intercept to be zero.© 2014 eScience Labs, LLC.All Rights Reserved8. Estimate the slope of the line and compare the slope to the index of refraction for water (n = 1.33) with a percent error calculation. Explain any discrepancies.9. Do you always observe a reflected ray of light as you increase the incident angle? What happens to the intensity of the reflected light as you increase the incident angleand eventually cross the critical angle?© 2014 eScience Labs, LLC.All Rights


View Full Document

TAMU PHYS 1402 - lab 6.2

Download lab 6.2
Our administrator received your request to download this document. We will send you the file to your email shortly.
Loading Unlocking...
Login

Join to view lab 6.2 and access 3M+ class-specific study document.

or
We will never post anything without your permission.
Don't have an account?
Sign Up

Join to view lab 6.2 2 2 and access 3M+ class-specific study document.

or

By creating an account you agree to our Privacy Policy and Terms Of Use

Already a member?