EGR 110 Due: Beginning of next classroom lecture Engineering Graphics File: N110SA5 Sketching Assignment #5 Reading Assignment: Read the following chapters in Engineering Graphics Workbook, Series 1.2 by Craig & Craig: Chapters L – Dimensioning Chapter M - Tolerancing Sketching Assignment: (staple all sheets together in the order assigned before submitting) Handout: #47: Dimension neatly using metric dimensions in mm (to the nearest whole mm) Use notes for fillets and rounds when possible Add a note indicating a general tolerance of ±0.5 mm Use appropriate symbols for the countersunk hole. Include a dimension for the angle. Use a metric scale (or the attached printed scale). Handout: #48: Dimension neatly using decimal-inch dimensions (accurate to the nearest hundredth of an inch) Use notes for fillets and rounds when possible Add a note indicating a general tolerance of ±0.005 Indicate that the small holes in Figure 1 are drilled. Use appropriate symbols for the counterbored hole in Figure 1. Indicate a tolerance for the hole in Figure 2 of ±0.002 Use a decimal-inch scale (or the attached printed
View Full Document