Ocean PowerWhat is OTECHow Does it WorkPowerPoint PresentationHistoryHistory Cont’dSlide 7Open-CycleSlide 9Closed-Cycle (Rankine)Closed LoopHybrid SystemAdvantagesSlide 14Artists rendition of a 400MW plant back in ‘75Slide 16Recent AdvancementsThe FutureResourcesOcean Power Ed Lemery, Brooke Scatchard, Nate TrachimowiczWhat is OTEC•OTEC, or Ocean Thermal Energy Conversion, is an energy technology that converts solar radiation to electric power.•OTEC systems use the ocean's natural thermal gradient—the fact that the ocean's layers of water have different temperatures—to drive a power-producing cycle.How Does it Work •Carnot Efficiency (T1-T2)/T1: in transferring heat to do work, the greater the spread in temperature between the heat source and the heat sink, the greater the efficiency of the energy conversion. •As long as the temperature between the warm surface water and the cold deep water differs by about 20°C (36°F), an OTEC system can produce a significant amount of power with a maximum Carnot Efficiency of about 6.7%•Half of the earths incoming solar energy is absorbed between the tropic of Capricorn and the Tropic of Cancer.History•1881: Jacques Arsene d'Arsonval, a French physicist, was the first to propose tapping the thermal energy of the ocean. Georges Claude, a student of d'Arsonval's, built an experimental open-cycle OTEC system at Matanzas Bay, Cuba, in 1930. The system produced 22 kilowatts (kW) of electricity by using a low-pressure turbine. In 1935, Claude constructed another open-cycle plant, this time aboard a 10,000-ton cargo vessel moored off the coast of Brazil. But both plants were destroyed by weather and waves, and Claude never achieved his goal of producing net power (the remainder after subtracting power needed to run the system) from an open-cycle OTEC system.•1956: French researchers designed a 3-megawatt (electric) (MWe) open-cycle plant for Abidjan on Africa's west coast. But the plant was never completed because of competition with inexpensive hydroelectric power.History Cont’d•1979: The first 50-kilowatt ( (kWe) closed-cycle OTEC demonstration plant went up at NELHA. •Known as "Mini-OTEC," the plant was mounted on a converted U.S. Navy barge moored approximately 2 kilometers off Keahole Point. The plant used a cold-water pipe to produce 52 kWe of gross power and 15 kWe net power.•1993: An open-cycle OTEC plant at Keahole Point, Hawaii, produced 50,000 watts of electricity during a net power-producing experiment. •This broke the record of 40,000 watts set by a Japanese system in 1982. •Today, scientists are developing new, cost-effective, state-of-the-art turbines for open-cycle OTEC systems, experimenting with anti corroding Titanium and plastics as rotor material.•The new designs for OTEC are still mostly experimental. Only small-scale versions have been made. The largest so far is near Japan, and it can create 100 kilowatts of electricity.Open-Cycle•Open-cycle OTEC uses the tropical oceans' warm surface water to make electricity. When warm seawater is placed in a low-pressure container, it boils. The expanding steam drives a low-pressure turbine attached to an electrical generator. The steam, which has left its salt behind in the low-pressure container, is almost pure fresh water. It is condensed back into a liquid by exposure to cold temperatures from deep-ocean water.Closed-Cycle (Rankine)•Closed-cycle systems use fluid with a low-boiling point, such as ammonia, to rotate a turbine to generate electricity. Here's how it works. Warm surface seawater is pumped through a heat exchanger where the low-boiling-point fluid is vaporized. The expanding vapor turns the turbo-generator. Then, cold, deep seawater—pumped through a second heat exchanger—condenses the vapor back into a liquid, which is then recycled through the system.Closed LoopHybrid System Hybrid systems combine the features of both the closed-cycle and open-cycle systems. In a hybrid system, warm seawater enters a vacuum chamber where it is flash-evaporated into steam, similar to the open-cycle evaporation process. The steam vaporizes a low-boiling-point fluid (in a closed-cycle loop) that drives a turbine to produces electricity.Advantages•Low Environmental Impact•The distinctive feature of OTEC energy systems is that the end products include not only energy in the form of electricity, but several other synergistic products.•Fresh WaterThe first by-product is fresh water. A small 1 MW OTEC is capable of producing some 4,500 cubic meters of fresh water per day, enough to supply a population of 20,000 with fresh water.•FoodA further by-product is nutrient rich cold water from the deep ocean. The cold "waste" water from the OTEC is utilised in two ways. Primarily the cold water is discharged into large contained ponds, near shore or on land, where the water can be used for multi-species mariculture (shellfish and shrimp) producing harvest yields which far surpass naturally occurring cold water upwelling zones, just like agriculture on land.Minerals OTEC may one day provide a means to mine ocean water for 57 trace elements. Most economic analyses have suggested that mining the ocean for dissolved substances would be unprofitable because so much energy is required to pump the large volume of water needed and because of the expense involved in separating the minerals from seawater. But with OTEC plants already pumping the water, the only remaining economic challenge is to reduce the cost of the extraction process.Artists rendition of a 400MW plant back in ‘75Recent Advancements•The development of the Kalina Cycle which is significantly more efficient than the previous closed-cycle system based on straight ammonia. •http://www.ocees.com/mainpages/qanda.html#faq3•The discovery that dissolved gases exchange more rapidly from seawater than from fresh water. This allows for more efficiency and lower costs for open-cycle OTEC and for fresh water production from seawater in a hybrid Kalina Cycle configuration as well as fresh water production in general. •The development of better heat exchangers and heat exchanger operation with respect to bio-fouling control (on the warm water side) and corrosion control.•Records available from experimental plants demonstrate technical viability and provide invaluable data on the operation of OTEC plants. The economic evaluation of OTEC plants indicates that their commercial future lies in
View Full Document
Unlocking...