BAE2023 Spring ‘10: Pumps1. What is the best efficiency point (BEP) of the pump represented by the performance curve below? What is the shutoff head if the impeller diameter is 11”?2. The centrifugal pump represented by the curve in problem number one has been operating at 250 GPM and has an impeller diameter of 12”. Due to piping reconfiguration and system streamlining on the discharge side of the pump, the pump must work against a reduction of 30’ head. We will need to resize the impeller. Maintaining the same capacity, to what diameter should the impeller be machined?3. A centrifugal pump is attached to a variable speed drive. The original operating conditions are 100 gpm, 80’ head, 1750 rpm. Using the affinity laws, calculate the speed and horsepower required to gain an additional 25 gpm. The impeller diameter can not be changed.4. Find the NPSH for the following three systems given on the next page.Problem 4:5. Given the pump represented by the curve below and the system sketch, find the total head, the capacity or pumping rate, impeller diameter, efficiency, motor size and speed requirement, and NPSHR. Would the NPSHR requirement
View Full Document