Class 1b: Introduction to mapsWhat is a map?Why make maps?Slide 4Slide 5Slide 6Slide 7How do we read maps?Map scaleSlide 10Slide 11Slide 12Slide 13Slide 14Map symbolizationSlide 16Point symbolsSlide 18Slide 19Slide 20Line symbolsSlide 22Slide 23Slide 24Area symbolsSlide 26Slide 27Slide 28Slide 29Topographic mapsSlide 31Slide 32Slide 33Map-reading exerciseClass 1b:Introduction to mapsWhat is a map?•A generalized view of an area, usually some portion of Earth’s surface, as seen from above at a greatly reduced size•Any geographical image of the environment•A two-dimensional representation of the spatial distribution of selected phenomenaWhy make maps?•To represent a larger area than we can see•To show a phenomenon or process we can’t see with our eyes•To present information concisely•To show spatial relationshipsRepresent a larger areaShow what we can’t seePresent info conciselyShow spatial relationshipsHow do we read maps?•Maps are selective views of reality•Size of the map relative to reality (scale)•What’s on the map (symbolization)•Shape of the map (projection)Map scale•Ratio of the distance on the map to the distance on the ground•Scale is a fraction•Larger area covered means larger denominator•Larger denominator means smaller fraction•So a la rge-sca le map covers a small areaLarge-scaleSmall-scaleMap scale•Ratio of the distance on the map to the distance on the ground1. Graphic:•Stays the same when photocopied•Might not be right for the whole mapMap scale2. Verbal:1 inch equals 10 miles•Easy to understand•Can change if photocopiedMap scale3. Representative fraction or ratio:1:24,000•Units don’t matter•Can change if photocopiedMap symbolization•Symbols are a code instead of text•Three kinds: point, line, area•Consider shape, size, orientation, pattern, color, valuePoint symbols•Every symbol counts as one occurrence•Qualitative points–Indicate location–Can also describe that location•Quantitative points–Show a distribution–Indicate a value (graduated symbols)Indicate locationDescribe locationShow a distributionIndicate a valueLine symbols•One-dimensional•Mostly taken for granted (borders, roads)•Isolines connect same values•Flow-line maps indicate value by width of lineIsolines(Contourlines)Flow-line mapsArea symbols•Each territory or region has one value•Differences in kind•Differences in value–Choropleth maps –Usually, darker indicates more•Cartograms distort area to show valueDifferences in kindDifferences in kindDifferences in value(Choropleth)CartogramTopographic maps•Also called quadrangles•Nearly 54,000 for the U.S.•Done by the US Geological Survey (USGS) since 1897•Map out the entire country in a standard fashionTopographic maps•Till the 1940s, you climbed to the highest point and plotted what you could see from there•Aerial photography after WWII•Two overlapping photos are put in a stereoscope•10 photos for each 7.5 minute mapTopographic maps•Show 2D features, point, line and area; also show 3D via contour lines•Common symbols are in the appendix of the text•Note the contour interval at the bottom of the mapMap-reading
View Full Document